How To Change Your Lens - Winderness Sunglasses
- To remove, start by pulling one side of the frame's corner outward & upward as depicted below.
- Repeat the same step on the opposite side.
- Hold the frame at the center bridge (B) (between the lens), and pull straight up to detach and remove the lens from the frame.
- After removing the lens from the frame, remove the nose pad by pulling the plastic part inward from the lens groove. Then, insert the nose pad on the spare lens by aligning the channel of the nose support piece (to the lens), and push upwards to secure the nose pad. Note: While performing this step, be cautious while removing and inserting the nose pad back into place to avoid deforming the pad.
1: Place the corner of lens (A) into the notch of the frame. Ensure the notch on the lens is in the recess; the lens should smoothly fit into the groove.
2: Pull frame around to engage the other side of the lens into place by repeating the same steps above (A) - Double check to ensure the lens is fully inserted into the groove of the frame.
3: Slide the middle of the frame over the center notch in the lens and push downward at the center of the frame until it snaps evenly into the lens. Be careful not to squish the nose piece while performing the steps above and utilize the microfiber bag to help minimize smudging or scratching the lens during removal & assembly.